27
Change Passcode Type
I have this feature.
I do not have this feature.
This feature allows those with Owner type passcodes to change
the passcode type for each of the users in the system. You cannot
change your own passcode type.
Passcodes can be one of three types: owner, user, or one-time.
• Owner type passcodes can re-configure how the system
responds to “watched” points. In addition, the Owner passcode
can be used to change other users’ “type” and can change
other users’ passcodes.
• User type passcodes are given to most users of the system,
and allow all but owner functions to be performed.
• One-Time passcodes allow the user to disarm the system one
time only. You can give them to temporary users, such as
housekeepers or service workers.
1. Make sure that the system is turned off.
2. Press the 6 key. The point lights (1 - 8) come on, showing the
current passcode type for users 1 - 8.
3. Enter your passcode. (Owner Type required).
4. Press keys 1 to 8 to toggle passcode types. Key 1 for User 1
and so on. For example, if light 3 is winking (User Type), pressing
key 3 changes the passcode type for User 3 to One-Time. Light
3 changes from wink to on.
Pressing 3 again toggles the passcode to the Disabled Type, as
indicated by the light, which turns off. Pressing 3 a third time
changes the passcode to the Owner Type, as indicated by the fast
blinking light. To remove a passcode, change its type to disabled.
5. When you are finished, press CLEAR to return to the off display.
71-07374-000-B Users Guide.p65 08/21/2001, 1:06 PM27
To Next Page
Loading...
Need help?
General
