- 19 -
5.6. TEMPORARY MEASURING UNIT
Function enables selecting a measuring unit which is to be indicated next to mass reading during the
operation. The set measuring unit will be in use from the moment of its activation until its change or
switching the balance off and on.
Each pressing of the
button results with change of the measuring unit.
Options:
• For verified balances, you can select from the following: [g], [mg] or [kg], [ct]
• For non-verified balances, you can select from the following: [g], [mg], [kg], [ct], [lb], [oz], [ozt],
[dwt], [tlh], [tls], [tlt], [tlc], [mom], [gr], [ti], [N]
5.7. UNITS ACCESSIBILITY
By pressing button
, the user may declare units to be available for selection of temporary unit.
Units with parameter value set to <YES> are available for selection in specified operating modes.
Procedure:
5.8. START UNIT SELECTION
Upon selection of start unit, the balance activates with the specified unit for these modes where
change of the unit is possible.
Ability of selecting a given unit depends on the balance status, i.e. if the balance is verified or not.
Procedure:
To Next Page
Loading...
Need help?
General
