To Next Page

To Previous Page

- 41 -

11.2.5. WEIGHING Mode Settings - Readout

The software allows setup of operating parameters (filters, value release and autozero function,

deleting the last digit and other settings) separately for each working mode. Only for User profile you

can modify all settings. For other profiles (Fast, Fast dosing, Precision) Filter and Value release

parameters are default and cannot be modified.

It enables customizing the instrument and utilizing its properties depending on your needs and

expectations, or on specific requirements for selected working mode (e.g. DOSING); as a result the

device operation is quick and easy.

Filter level setting (function unavailable for the following profiles: Fast, Fast dosing,

Precision)

Filter settings adjustment depends on the working environment. For the best possible conditions the

filter can work in a very fast mode (V.FAST value for Filter parameter); however, if the conditions are

poor (shakes, drafts), the filter should be set to slow or very slow option (SLOW or V. SLOW value for

Filter parameter). The effectiveness of the filter is different throughout the weighing range. The filter

works slower when “approaching” the weighed mass, it works more intensively for weighed mass

within the set range of the filter (the parameter for setting filter range is accessible only from the

service menu – the user does not have any access to it).

Depending on the filter, the weighing time is shorter (V.FAST and FAST) or longer (SLOW and V.

SLOW).

Value release (function unavailable for the following profiles: Fast, Fast dosing, Precision)

Since ambient conditions at a workplace vary, it is necessary to determine the value release

parameter in the most preferable way enabling balance adaptation, parameter options are:

FAST.+REL., FAST or RELIABLE. Depending on the selected option, weighing time is either shorter

or longer.

Autozero function

The software features an autozero function (Auto) ensuring precise mass indication. This function

automatically controls and corrects zero indication. When Autozero is enabled, it compares balance

indications at declared time intervals e.g. 1s, provided that weighing pan is unloaded and display

RADWAG AS R2 PLUS User Manual

Other manuals for RADWAG AS R2 PLUS