- 84 -
Send stable measurement result in basic measuring unit
Immediately send measurement result in basic measuring unit
Send stable measurement result in current measuring unit
Immediately send measurement result in current measuring unit
Switch on continuous transmission in basic measuring unit
Switch off continuous transmission in basic measuring unit
Switch on continuous transmission in current measuring unit
Switch off continuous transmission in current measuring unit
Set min checkweighing threshold
Set max checkweighing threshold
Give value of min checkweighing threshold
Give value of max checkweighing threshold
Set mass value of a single item
Give balance serial number
Internal adjustment performance
Disable automatic internal adjustment of the balance
Enable automatic internal adjustment of the balance
Give available working modes
Give current working mode
Send all implemented commands
Set ambient conditions state
Give currently set ambient conditions
Give current value release
Cooperation with PUE 7.1, PUE 10 terminal
CAUTION!
Each command must end with CR LF characters;
15.2. RESPONCE FORMAT
On receipt of a command, the terminal responds as follows:
command understood and in progress
command carried out (appears only after the command XX_A)
command understood but not accessible at this moment
command understood but max threshold is exceeded