RADWAG AS R2 PLUS User Manual

- 74 -
2.
Having completed driver installation, connect balance
to a computer, use 1,8-
meter long USB A/B cable
maximally (in case of already connected balance, it is
necessary to disconnect it and using USB cable
connect the balance again).
3.
The system detects the new USB device and automatically starts searching a respective driver
4.
Go to Device Manager and check number assigned to
virtual COM port.
For this very case it is
STMicroelectronics Virtual
COM Port (COM3).
5.
Set balance parameters: select USB value for parameter COMPUTER/PORT.
6.
Run software for measurement readout.
7.
Use the program to set parameters for communication – select respective COM port (for the
very case it is COM8), i.e. the one which has been formed while installing drivers.
8.
Start cooperation.

RADWAG AS R2 PLUS Specifications

General

Brand	RADWAG
Model	AS R2 PLUS
Category	Analytical Instruments
Language	English