RADWAG PS 6000.R2 User Manual

- 45 -
Automatic operation proceeds as follows:
 Press button to zero the balance (marker of stable
measurement
and zero marker are shown on display)
 Place the load, the balance sends the first stable measurement to
the printer port,
 Remove the load from the balance,
 Next measurement is possible when the reading on the display is
lower than the set value of < AUTO THRES. > parameter (next
measurement does not require zero value).
This procedure applies to changing settings:
For automatic working mode adjust the threshold value.
< AUTO THRES. > parameter is connected with the following functions:
- automatic tare,
- automatic operation,
For automatic operation function the measurement will not be send from the
computer to the printer as long as the mass measurement stays withing the set
value range < P 2.2.3.2 PROG THRES>.

RADWAG PS 6000.R2 Specifications

General

Brand	RADWAG
Model	PS 6000.R2
Category	Scales
Language	English