5. BASIC FUNCTIONS
• Functions related to measuring units
- Setting default measuring unit <StUn>,
- Weighing in grams [g],
- Weighing in milligrams [mg] (in balances with d=0,001 g)
- Weighing in kilograms [kg] (in balances with d=0,01 g)
- Weighing in [ct],
- Weighing in units from beyond SI (available only in non-verified
instruments: [lb], [oz], [ozt], [dwt], [t], [mom], [gn].
• Functions related to working modes
- Parts counting < PcS>,
- Checkweighing (Control +/-) <HiLo>,
- Percent setup <Perc A>, <Perc B>,
- Density determination of solids <d_Co>
- Density determination of liquid <d_Li>,
- Totalizing <Add>,
- FiLL mode <FiLL>.
• Functions related to setting a balance to ambient conditions at a
workstation
- Enabling / Disabling autozero system <Auto>,
- Setting parameter of measurement result averaging <AuE>,
- Value release <ConF>,
- Weighing mode <rAPd>,
- Display backlight <bl>,
- Display brightness <bLbA>,
- Beep signal <bEEP>.
• Function relating to use of RS 232 interface
- Setting baud rate <bAud>,
- Continuous data transmission in basic measuring unit <CntA>,
- Continuous data transmission in current measuring unit <Cntb>,
- Automatic operation mode <rEPL>.
Balance PS series can be used to weigh loads under the weighing platform – i.e.
under hook weighing option.
Balance software enables generating a report from adjustment process in a form of
a printout containing modifiable data (see GLP procedures).
To Next Page
Loading...
