RADWAG PS Series

55
14. BALANCE WORKING MODES
- Weighing mode – bASic
- Parts counting – PcS
- Checkweighing – HiLo
- Percent setup with reference mass determined by weighing – PrcA
- Percent setup with reference mass determined by a user – PrcB
- Density determination of solids – d_Co
- Density determination of liquid – d_Li
- Totalizing – Add
- Working mode Fill – FiLL
Press MODE key:
Pressing MODE key causes display of the first available mode. Each next pressing
of
or key causes displaying name of next available mode. The way of
setting a working mode is described in further section of this manual.