RADWAG PS Series

75
15.3. Setting operation mode for RS 232 interface
no – manual operation (enabled on pressing PRINT key)
YES – automatic operation (enabled on stabilization of weighing
result).
Return to weighing
(see point – 8.2. – return to weighing).
Automatic operation takes place according to the following scheme:
 press Esc/TARE key to zero the balance (display will indicate
pictograms of stable measurement
and precise zero )
 place the load, balance will send first stable measurement through the
RS232 interface
 remove the weighed load from the weighing pan,
 next measurement can be conducted if a weighing result equals +/- 50
reading units from zero (it is not necessary to reach precise zero to
start another measurement).