RADWAG PS Series

To Next Page

To Previous Page

9.3.2. Means of selecting one of available working modes

Balance user can enable or disable modes which are not used in the

weighing process. This provides quicker access to modes used on a

balance.

On – mode available OFF – mode disabled

Main Page

Default Chapter3
- Table of Contents3
1 Technical Data7
2 Basic Information9
- Intended Use9
- Inappropriate Use9
- Warranty9
- Monitoring the Metrological Parameters of the Instrument10
- Data Included in this User Manual10
- Staff Training10
3 Transport and Storage10
- Delivery Check10
- Packaging10
4 Unpacking, Assembling and Startup11
- Assembling and Place of Use11
- Unpacking11
- Leveling13
- Standard Equipment of a Balance13
- Cleaning13
- Plugging to Mains13
- Connecting Peripheral Devices13
5 Basic Functions14
6 Keyboard15
7 Start-Up16
8 User Menu17
- Moving through User Menu17
- Moving through User Menu20
9 Weighing21
- Selection of Basic Measuring Unit22
- Temporary Measuring Unit23
- Setting Accessibility of Balance Working Modes24
  - Selection of Working Modes Available for a User25
  - Means of Selecting One of Available Working Modes27
- Dual Range Balance (PS 200/2000/C)28
10 Balance Main Parameters29
- Setting Level of Filtering29
- Value Release31
- Autozero Function32
- Blanking of the Last Digit on the Display33
- Weighing Mode RAPID34
11 Other Parameters35
- Backlight of Weighing Result (Display Backlight)36
- Adjusting Display Brightness36
- Beep" Sound - Reaction on Pressing Function Key38
- Printout of All Balance Parameters through RS 232 Port39
12 Balance Adjustment40
- Internal Adjustment41
- Menu Adjustments Settings42
- Adjustment Test46
  - Balances with Internal Adjustment46
  - Balances with External Adjustment47
- Manual Adjustment48
  - Internal Adjustment48
  - External Adjustment49
- Adjustment Report Printout50
13 Determining Content of a Printout for Glp Procedure51
14 Balance Working Modes55
- Parts Counting of the same Mass56
- Checkweighing (Hilo) with Reference to Set Standard59
- Percent Setup62
  - Reference Mass Determined by Weighing63
  - Reference Mass Inserted to Balance Memory by a User64
- Working Mode Fill65
- Density Determination of Solids and Liquids67
  - Testing Thickness Solids68
  - Testing Thickness of Liquid68
- Totalizing69
15 Rs 232 Functions71
- Baud Rate72
- Continuous Transmission73
  - Continuous Transmission in Basic Measuring Unit73
  - Continuous Transmission in Current Measuring Unit74
- Setting Operation Mode for RS 232 Interface75
- Determination of Data Type Sent through RS 232 Output76
- Minimal Mass Required for Activation of Automatic Printout77
16 Cooperation with a Printer or a Computer78
- Cross-Section through Connecting Conductors79
- Printing Date with Specified Date and Time80
- Cooperation with Statistic Printer Kafka SQS80
- Format of Data Sending81
- Format of Data Sent on Pressing of PRINT Key81
  - Format of Data Sent as Response for Commands Generated from a Computer82
17 Under Hook Weighing83
18 List of Commands Computer - Balance84
19 Error Messages86
20 Additional Equipment87
- Anti-Vibration Table87
- Rack for under Hook Weighing87
- Density Determination Kit (for Solids and Liquids)87
- Additional Display87
- Computer Software88

Table of Contents

Other manuals for RADWAG PS Series

Related product manuals