Rain Master RME EAGLE - Page 129

RME EAGLE User Manual Rain Master Irrigation Systems
Page 122 Appendix A Controller Displays
= This display appears in three different controller instances, if
flow monitoring has been enabled.
1. Flashes when an irrigation program is executing.
2. In Manual System Check/Syringe Cycle.
3. Displayed when the controller is measuring flow
while LEARNING each stations Upper Flow Limit.
= Measured flow is displayed on the left side of display and the
upper flow limit for the station on the right.
A.1.12 MANUAL Prompts and Displays
= The MANUAL function allows you to independently control a
station or an irrigation program.
= The controller prompts you to select a program to run or a
station to turn-on.
= You have selected to manually start a program and the
controller is prompting for the irrigation program to run.
= You have selected to manually turn on a station and the
controller is prompting for the valve (or station).
= You have selected to manually turn on a station and the
controller is prompting for the runtime length.
A.1.13 SKIP DAYS Prompts and Displays
= The SKIP DAYS key has been pressed and the controller will
prompt for the number of days between irrigation cycles (30
day cycle).
= The number of days left before the Skip Day’s cycle will start
irrigation.
MANUAL
PROGRAM
P OR S
PROGRAM
PROG-
PROGRAM
STA-
PROGRAM
1- LN
PROGRAM
3 SD-
PROGRAM
3 LFT-00
PROGRAM
100 GPM
PROGRAM
123 200
PROGRAM