Rain Master RME EAGLE - Command Execution Keys

Rain Master Irrigation Systems RME EAGLE User Manual
Chapter 4 Controller and Front Panel Operation Page 33
All Data Entry actions are completed only after you press the ENTER key. The controller will
process the data, check the data validity and then accepted or rejected the data. If the data is
acceptable the controller will display “OK”, if the data is unacceptable the controller will display
“NO” and you will be required to re-enter the correct data value.
4.2.3 Command Execution Keys
The Command Execution Keys are used to complete the entry of data values, terminate data entry
and to clear unwanted parameters.
CLEAR
QUIT ENTER