Rain Master RME EAGLE - 7.3 ENTERING THE ET REFERENCE VALUE

RME EAGLE User Manual Rain Master Irrigation Systems
Page 90 Chapter 7 ET Key Operations
NOTE: The RME EAGLE controller allows the four programs to be ET based
programs, conventional irrigation programs, or any combination of the two
program types.
The controller will return to the Automatic Mode.
7.3 ENTERING THE ET REFERENCE VALUE
The ET Reference value is an important parameter, required by the controller, in order to realize ET
water savings. Please refer to section 8.4 ESTABLISH THE ET REFERENCE VALUE to
determine how this value is derived. The reference value (measured in inches) closely coincides
with the reference program defined in section 8.3 GENERATE THE REFERENCE PROGRAM.
EXAMPLE: Enter an ET Reference value of .13,
Continue to Press: Until display indicates:
Press: Display will indicate:
Press:
The controller will return to Automatic Mode.
EXAMPLE: Review the ET Reference value,
Continue to Press: Until display indicates:
Press: To review the Monthly ET value for January,
Press:
The controller will return to Automatic Mode.
ETREF .13
PROGRAM
ET
ETREF
PROGRAM
ENTER
QUIT
1
SUN
3
TUE
ET
ETREF .13
PROGRAM
QUIT
ET