Raisecom ISCOM2600 (B) Series - Leds; Table 2-7 Parameters of the SNMP Interface; Table 2-8 Leds

Raisecom
ISCOM2600 (B) Series Product Description
2 System structure
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
29
Table 2-7 Parameters of the SNMP interface
Parameter
Description
Connector type
RJ45
Transmission rate
10/100/1000BASE-T auto-negotiation
Wiring
Support adaption to the straight-through cable and crossover cable
in host mode.
Standard
IEEE 802.3
2.3 LEDs
Table 2-8 lists LEDs.
Table 2-8 LEDs
LED
Status
Description
LNK/ACT
Green
Ethernet interface working status LED

Green: the interface is properly connected.

Blinking green: the interface is receiving or sending data.

Off: the interface is disconnected or improperly connected.
LNK/ACT
Green
10 Gbit/s SFP+ interface working status LED

Green: the interface is properly connected.

Blinking green: the interface is receiving or sending data.

Off: the interface is disconnected or improperly connected.
PWR
Green
Power working status LED

Green: the power supply is normal.

Off: the power supply is off, the power module is installed
improperly or fails.
SNMP
Green
SNMP interface working status LED

Green: the SNMP interface is properly connected.

Blinking green: the SNMP interface is receiving or sending
data.

Off: the SNMP interface is disconnected or improperly
connected.
SYS
Green
System working LED

Green: the system is working improperly.

Blinking green (every 1s): the system has loaded the
configuration file or the device is configured.

Off: the system is working improperly.