To Next Page

To Previous Page

Getting Started

R&S

FSVA3000/ R&S

FSV3000

41User Manual 1178.8520.02 ─ 01

The serial number can be found on the rear panel of the instrument. It is the third part

of the device ID printed on the bar code sticker:

For example, FSV3007-123456

To change the computer name

1. Press the [Setup] key and then the "Network + Remote" softkey.

The current "Computer Name" is displayed in the "Network" tab.

2. Enter the new computer name.

3. Close the dialog box.

5.1.5.4 Changing the Windows Firewall Settings

A firewall protects an instrument by preventing unauthorized users from gaining access

to it through a network. Rohde & Schwarz highly recommends the use of the firewall on

your instrument. Rohde & Schwarz instruments are shipped with the Windows firewall

enabled and preconfigured in such a way that all ports and connections for remote

control are enabled.

For more details on firewall configuration, see the following Rohde & Schwarz White

Paper:

●

1EF96: Malware Protection Windows 10

Note that changing firewall settings requires administrator rights.

5.1.6 Configuring the Initial Instrument Settings

This section describes how to set up the R&S FSV/A initially. For further basic instru-

ment settings, see the R&S FSV/A User Manual.

● Setting the Date and Time...................................................................................... 41

5.1.6.1 Setting the Date and Time

Assuming you have administrator rights, you can set the date and time for the internal

real time clock as follows:

Opening the Date and Time Properties dialog box

1. Press the [SETUP] key.

Preparing for Use

R&S FSV3030 User Manual

Other manuals for R&S FSV3030