R&S FSV3030 User Manual

Data Management
R&S
®
FSVA3000/ R&S
®
FSV3000
534User Manual 1178.8520.02 ─ 01
QuickSave 1 / ... / QuickSave 10 ............................................................................... 534
Storage Type (Save only) ...........................................................................................534
Recall ......................................................................................................................... 534
QuickSave 1 / ... / QuickSave 10
Selects one of the save sets to store the current settings in or to be recalled. At the
time of storage, the "QuickSave 1 / ... / QuickSave 10" placeholder is replaced by a
label indicating the storage date and time and the storage type.
During recall, save sets of type "Instrument" replace the settings of the entire instru-
ment. All other save sets start a new channel with the stored settings.
Note: Saving instrument settings in secure user mode.
Settings that are saved via Quick Save in secure user mode are only available during
the current session. As soon as the power is switched off on the R&S FSV/A, the data
is cleared (see Chapter 5.1.7, "Protecting Data Using the Secure User Mode",
on page 42).
Storage Type (Save only)
Defines which type of settings are stored in the save set.
"Instrument
with all Chan-
nels"
The instrument settings for all currently active "Channel" s are stored.
"Current Chan-
nel"
Only the instrument settings for the currently selected measurement
"Channel" s are stored.
Recall
Restores the instrument settings as saved in the selected settings file. If the settings
file contains settings for a specific "Channel" only, a new channel with the stored set-
tings is activated, otherwise all "Channel" s and instrument settings are overwritten
with the stored settings.
Note: After you use the "Recall" function, the history of previous actions is deleted, i.e.
any actions performed previously cannot be undone or redone using the [UNDO/
REDO] keys.
Remote command:
MMEMory:LOAD:STATe on page 1070
11.3.2 Configurable Storage and Recall
The more sophisticated storage and recall functions allow you to define which settings
are stored, and where the settings file is stored to. Any settings file can be selected for
recall.
● Stored Data Types................................................................................................ 535
● Storage Location and Filename............................................................................ 535
● Save and Recall Dialog Boxes..............................................................................535
● Startup Recall Settings..........................................................................................538
Storing and Recalling Instrument Settings and Measurement Data

R&S FSV3030 Specifications

General

Frequency Range	10 Hz to 30 GHz
Input Impedance	50 Ω
Input VSWR	< 1.5:1
Input Power Level	+30 dBm
Display	1280 x 800 pixels
Power Supply	100 V to 240 V, 50 Hz to 60 Hz
Resolution Bandwidth	1 Hz to 10 MHz (1 Hz to 50 MHz with option)
Displayed Average Noise Level (DANL)	-165 dBm (1 Hz RBW)