R&S FSV3030 User Manual

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
730User Manual 1178.8520.02 ─ 01
14 Remote Commands
The commands required to perform measurements in the Spectrum application in a
remote environment are described here.
It is assumed that the R&S FSV/A has already been set up for remote operation in a
network as described in Chapter 13.6, "How to Set Up a Network and Remote Con-
trol", on page 710.
Compatibility with former R&S signal and spectrum analyzers
As a rule, the R&S FSV/A supports most commands from previous R&S signal and
spectrum analyzers such as the FSQ, FSP, FSU, or FSV. However, the default values,
in particular the number of sweep points or particular bandwidths, may vary. Therefore,
the R&S FSV/A can emulate these other devices, including their default values, in
order to repeat previous measurements or support existing control applications as in
legacy systems.
● Conventions Used in SCPI Command Descriptions............................................. 730
● Common Suffixes..................................................................................................731
● Common Commands............................................................................................ 731
● Selecting the Operating Mode and Application.....................................................736
● Configuring and Performing Measurements......................................................... 744
● Configuring the Result Display..............................................................................875
● Setting Basic Measurement Parameters...............................................................885
● Analyzing Measurements (Basics)........................................................................955
● Managing Settings and Results.......................................................................... 1059
● Configuring the R&S FSV/A................................................................................1090
● Using the Status Register....................................................................................1152
● Commands for Remote Instrument Operation.................................................... 1156
● Emulating Other Instruments' Commands.......................................................... 1157
● Deprecated Commands...................................................................................... 1195
● Programming Examples......................................................................................1198
14.1 Conventions Used in SCPI Command Descriptions
Note the following conventions used in the remote command descriptions:
●
Command usage
If not specified otherwise, commands can be used both for setting and for querying
parameters.
If a command can be used for setting or querying only, or if it initiates an event, the
usage is stated explicitly.
●
Parameter usage
If not specified otherwise, a parameter can be used to set a value and it is the
result of a query.
Parameters required only for setting are indicated as Setting parameters.
Parameters required only to refine a query are indicated as Query parameters.
Conventions Used in SCPI Command Descriptions

R&S FSV3030 Specifications

General

Brand	R&S
Model	FSV3030
Category	Measuring Instruments
Language	English