Getting Started
R&S
®
FSVA3000/ R&S
®
FSV3000
63User Manual 1178.8520.02 ─ 01
In the "Frequency" dialog box, set the center frequency to 64
MHz and tap "Zero
Span".
As the calibration signal does not vary over time, the level versus time diagram dis-
plays a straight line.
Figure 5-10: Time domain display of the calibration signal
5. Create a new channel for I/Q analysis:
a) Press the [Mode] key.
b) Tap the "IQ Analyzer" button to activate a channel for the I/Q Analyzer applica-
tion.
c) Tap the "Display Config" softkey to activate the SmartGrid mode.
Trying Out the Instrument
To Next Page
Loading...
