en-106
10 QUALITY OF CUT
NOTE: The Arrow indicates direction of travel.
“Scalping” is a condition in which some areas are
cut shorter than the set height of cut. This results in
very short grass or brown areas. The cause is a low
height-of-cut (HOC) setting, rough surface.
Possible Cause Correction
The HOC (height-of-cut) settings are low for the
conditions.
Check and adjust the HOC settings.
The mower can not follow the ground in this
direction.
Change the direction of cut.
Cutting at more than the recommended speed. Decrease the cutting speed.
10.3 SCALPING __________________________________________________________
To Next Page
Loading...
