en-30
5 CONTROLS
SERVICE MENU
Please note some functions require a PIN to access.
5.2.Z.14 SERVICE MENU ___________________________________________________
The button accepts the option that has the ü.
The is moved with the up and down to select, fault log, time until
service, diagnostics, I/O diagnostics and ECU (engine Control Unit) monitor.
5.2.Z.15 FAULT LOG_______________________________________________________
Select the fault log and accept .
5.2.Z.16 FAULT LOG_______________________________________________________
The last 50 “Faults” that the controller finds are recorded. When 50 faults are
recorded, the fault that next occurs will write over the oldest fault.
This information is got with the service tool or can be seen on the errors page of
the service menu. Press the button to select, press the button up and
down to move the ü. The errors will move with the last error at the top of the
screen.
The fault / data log function has three actions. Each fault / data log function can
contain a maximum of 50 faults. the areas included are:
The Inclinometer, records slopes of more than 22°.
The Engine, records the engine shut downs because of overheat or loss of oil pressure.
The Service, records hydraulic by-pass fault and missed service.
Service Menu
Fault Log
Time Until Service
Diagnostics
I/O Diagnostics
J1939
Service Menu
Fault Log
Time Until Service
Diagnostics
I/O Diagnostics
J1939
Fault Log
0 0 Hours
1 0 Hours
2 0 Hours
TST
™
To Next Page
Loading...
