en-114
10 QUALITY OF CUT
NOTE: The Arrow indicates direction of travel.
Areas of grass has been left uncut, and lays flat.
Possible Cause Correction
Mowing (ground) speed is too fast. Reduce mowing (ground) speed.
HOC set close to the actual grass height. Reduce HOC.
Too much material to clear rear of unit, brought
round the unit pushing over the grass.
Reduce mowing (ground) speed.
Lot of dead damp grass wrapped on the front of the
flail cutting edges, beating the grass down.
Cut when grass is less wet or replace damaged
blades.
Grass always cut in same direction. Cut grass in opposite direction.
10.11LAYING UNCUT GRASS ________________________________________________
To Next Page
Loading...
