en-112
10 QUALITY OF CUT
NOTE: The Arrow indicates direction of travel.
Marcelling, like wash boarding, is a cyclical pattern
of varying cutting heights, resulting in a wave-like cut
appearance. In most cases, the wave tip-to-tip
distance is 2 in. (5 cm) or less.
Possible Cause Correction
Mowing (ground) speed is too fast. Reduce mowing (ground) speed.
HOC (height-of-cut) setting is too low for turf
conditions.
Check/adjust HOC to turf conditions.
Flail Blade security or wear. Check & replace as necessary.
10.9 MARCELLING ________________________________________________________
To Next Page
Loading...
