Raspberry Pi Pico User Manual


NOTE
The pico directory will be created in the folder where you run the pico_setup.sh script.
Once it has run, you will need to reboot your Raspberry Pi,
$ sudo reboot
for the UART reconfiguration to take effect. Once your Raspberry Pi has rebooted you can open Visual Studio Code in
the "Programming" menu and follow the instructions from
Section 7.2.
Getting started with Raspberry Pi Pico
Chapter 1. Quick Pico Setup 5

Raspberry Pi Pico Specifications

General

Microcontroller	RP2040
Clock Speed	133 MHz
SRAM	264 KB
Flash Memory	2 MB
GPIO Pins	26
Operating Temperature	-20°C to +85°C
Architecture	ARM Cortex-M0+ (dual-core)
Interfaces	I2C, SPI, UART, PWM
Operating Voltage	1.8–5.5 V
Dimensions	51 mm × 21 mm