CHAPTER 3
14 Raven RS1™ and RS Lite™ Calibration and Operation Manual
FIGURE 7. Antenna Center Offset Page
8. Select the value box to enter the Antenna Center Offset position.
NOTE: The Antenna Center Offset position is calculated by measuring from the center of the machine to the
center of the RS1 unit. Enter a negative value if the RS1 unit is located to the left of the machine center
line.
9. Select the Next arrow.
FIGURE 8. Antenna Height Page
10. Select the value box to enter the Antenna Height.
NOTE: The Antenna Height is calculated by measuring from the ground to the center of the RS1 unit.
11. Select the Next arrow.
To Next Page
Loading...
