EasyManuals Logo

Raven SmarTrax Installation Manual

Default Icon
59 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
4
Manual No. 016-5034-004 37
Wheel Angle Sensor Installation
21. Secure the sensor mounting bracket to the machine using two M10 x 1.5 x 25 mm hex bolts (P/N 311-0070-
008), two 0.406” ID x 0.812” OD x 0.065” thick washers (P/N 313-2300-014), and two M10 x 1.5 nylon insert
lock nuts (P/N 312-4000-208).
Note: Do not fully tighten.
FIGURE 25. Sensor Shaft Installed in WAS Coupler
22. Insert the sensor shaft into the installed WAS coupler.
23. Tighten the installed nuts and bolts.
24. Installation is complete. Proceed to Chapter 5, Cab Component Installation.

Other manuals for Raven SmarTrax

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Raven SmarTrax and is the answer not in the manual?

Raven SmarTrax Specifications

General IconGeneral
BrandRaven
ModelSmarTrax
CategoryFarm Equipment
LanguageEnglish

Related product manuals