CHAPTER
3
Calibration Wizard: Camera and Equipment Calibration 11
CHAPTER 3
CALIBRATION WIZARD
The following sections offer assistance with the VSN system calibration wizard.
NOTE: For best results, take all measurements in operating conditions and measure to the nearest 1/4 inch
[nearest cm].
To reset or adjust the Machine Calibration, the VSN system must be reset to factory defaults.
CAMERA AND EQUIPMENT CALIBRATION
Refer to the following sections to get started with the VSN calibration for the specific application:
• Rear Boom Sprayers section on page 12
• Front Boom Machines section on page 14
• Implement section on page 16
• Radar Sensors section on page 18
To Next Page
Loading...
