CHAPTER 3
16 VSN® Operation Manual
IMPLEMENT
1. Use the Machine Type drop down list to select the Implement option.
2. Use the Machine Make and Model drop down lists to select your machine.
NOTE: If your machine make or model is not listed, select the Generic option.
3. Lower the implement to the working height.
4. Measure the height of the camera lens to the bottom of the furrow.
5. Use the on-screen keypad to enter the camera height.
FIGURE 7. VSN Camera Height
6. Select the Next button.
7. Next, measure and enter the distance from the working point of the implement to the camera lens.
NOTE: A positive value means the camera is located in front of the working point.
FIGURE 8. VSN Camera Fore/Aft Position
To Next Page
Loading...
