Raven VSN - Row Spacing Preset Calibration

CHAPTER 3
20 VSN® Operation Manual
ROW SPACING PRESET CALIBRATION
Complete the following steps to calibrate a row spacing preset on the VSN system.
IMPORTANT: VSN will only steer as well as the RS1/SC1 is paired. It is recommended that the RS1/SC1 has a properly
calibrated and tuned profile before calibrating the VSN. If you experience poor GPS steering you will
experience poor VSN steering.
NOTE: Up to 5 row spacing presets may be saved with the VSN system.
1. Select the Row Spacing button to proceed with the calibration process.
NOTE: If radar sensors are available, VSN may be run in a radar only mode. If no radar sensors are installed,
a row spacing calibration will need to be completed before the VSN camera may be used for row
guidance.
FIGURE 15. VSN Row Spacing Preset Selection
2. Enter the row spacing of the crop (in inches [cm]) in which the VSN steering system will be used.
3. Enable the Radar Only option to bypass the Row Spacing Calibration.
NOTE: If the Radar Only option is enabled, the system will skip the following calibration steps and the row
sensor source will be locked to radar sensors. This option may be useful when completing the
calibration in full canopy or late season crops where the VSN system may encounter lower visual
solution qualities.
Proceed to Chapter 4, Operation, for assistance with VSN operation in the Radar Only mode.