Service Manual Rayjet
Error codes
Software feedback
07/09/2010 Trotec Produktions- und Vertriebs GmbH_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support 37 / 53
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto: rayjet@troteclaser.com www.rayjetlaser.com
7 Error codes
The following error codes can be generated by the Trotec Minimanager, whenever it recognizes a
machine or computer problem. In many cases these codes are a helpful information which makes it
easier to sort out problems.
Nevertheless sometimes the indication of an error code can be confusing, because machine
errors (that are indicated by beeping and blinking of the machine) might cause a software error as
well although the true cause is the machine.
7.1 Software feedback
Number Text
0 // no error occured
-3 // Laser turned off
-100 // -2 (TP_ERR_INTERNAL) received from COMM module - mostly USB problems
-200 // Initialisation of com port failed
-201 // Echo packet not correctly received
-202 // Other transmission is in progress
-203 // Echo packet contains wrong data
-204 // Timeout occured
-205 // No data pending
-206 // Some "TP" function failed to succeed
-207 // No abort valid in this state
-208 // No abort valid in this state
-209 // Failed to allocate memory
-210 // Failed to allocate memory
-211 // Wrong WS spool size
-212 // Wrong WS spool size
-213 // Wrong WS spool size
-214 // Wrong JOB spool size
-215 // No jobs found to transmit
-216 // Jobs on platte have different params
-217 // canceld update of settings
-218 // Switch of com speed failed
-250 // transmission should idle here
-251 // communication not ready
-252 // could not write data to comm
-300 // firmware download aborted
-301 // could not open data file
-302 // no answer for datagram
-303 // RAM error
-304 // FLASH error
-305 // Could not clear RAM
-800 // Could not open job file
-801 // Could read file header
-802 // wrong file format
-803 // compressed data currently not supported
-804 // Could read info header
-805 // Could read cut info
-806 // Could send query command
-807 // Got no info from graver (timeout)
-808 // SetMark of loader failed
-809 // loader is out of sync
-810 // Wrong color depth encountered
To Next Page
Loading...
