3.2 Laser pointer adjustment
Attention: To do the laser pointer adjustment it is absolutely necessary to wear laser
protection glasses!
What you need:
laser protection glasses (for CO
2
lasers) part number 69300
the toolbox enclosed to your engraver
beam alignment tool (BAT) for mirror #3
What you have to know:
Connect the laser to the Manager and ensure that the testpulse setting within the Manager is set to
a low level (~10%) before doing the beam alignment.
The CO
2
laser beam is invisible. To find out its path, you use the BAT for CO
2
lasers. It is burned at
the spot, where it is hit by the laser beam and shows a mark.
The tolerable displacement (distance from burned dot to the centre) is one sixth of the diameter of
the mirror or hole where you do the adjustment.
1.) After you´ve installed the laser pointer put the BAT on the mirror #3 on the x-axis.
2.) Move the engraving head to the lower left corner of the engraving table (0/300).
3.) Press the “Start/Pause” and “Stop” buttons simultaneously until you see a little mark on the
BAT. This is only possible if all interlocks are closed.
4.) Adjust the three small screws close to the laser pointer until the red dot hits exactly the burned
spot on the BAT.
To Next Page
Loading...
