Service Manual Rayjet
Error codes
Hardware feedback
07/09/2010 Trotec Produktions- und Vertriebs GmbH_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support 39 / 53
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto: rayjet@troteclaser.com www.rayjetlaser.com
7.2 Hardware feedback
Machine errors are shown after 30 seconds!
Error Code 123 A device on the CAN bus is not working properly
Error Code 124 Switching Point density is too high
Error Code 125 Bitmapline not finished (with engraving mode only)
Error Code 126 Wrong combination of firmware / JobControl
Error Code 128 Firmware Update Error
Error Code 129 Fault of Laser DSP
Error Code 130 x-axis Lost positions
Error Code 134 Wrong Connection of x-axis encoder
Error Code 135 Wrong x-axis Encoder
Error Code 138 Illegal reference switch operation X axis
Error Code 146 y-axis lost positions
Error Code 146 y-axis lost positions
Error Code 150 Wrong Connection of y-axis encoder
Error Code 150 Wrong Connection of y-axis encoder
Error Code 152 Wrong connection of y-axis motor
Error Code 154 y-axis reference switch triggered
Error Code 162 z-axis lost positions
Error Code 166 Wrong Connection of z-axis encoder
Error Code 166 Wrong Connection of z-axis encoder
Error Code 169 z-axis limit switch triggered
Error Code 170 z-axis reference switch triggered
Error Code 194 rotary lost positions
Error Code 198 Wrong Connection of rotary encoder
Error Code 202 rotary reference switch triggered
This list is just a hint on where to look at. For detailed information on reasons and possible
solutions of the error code, please consult the Error Code list available on Merlin.
To Next Page
Loading...
