XC3000Series Motion Control System of Laser Cutting - User Manual
V1.0 Raytools AG © Copyright 60 |87
www.raytools.ch
Advanced
Parameter Default Remark
Power on delay: 2000 time of the machine enabled
Power control delay 6 Set the delay of the system power output.
Flycut control delay 0 Set the delay of the beam out when fly cutting.
Slag Removal Power Control Deselect. The control of power for slag removal is shown by the curve.
Prepiercing and Defilm:
Parameter Default Remark
Prepiercing/Film
type:
Group
Single Vector: select to process the single contours.
Whole board: select to process the whole board.
Group: select to process graphics in groups.
Sequence:
Prepiercing first: select to prepierce before defilming.
Defilm first: select to defilm before prepiercing
Prepiercing first
.
Z Coordinate Reset
Parameter Remark
Apply current Z coordinate Click and set current Z coordinate as 0.
3.13 OK, Cancel and Apply
· OK: click on OK to save the process parameters set for the layer and make it effective.
· Cancel: click on Cancel and the parameters set for the layer will be ineffective with the interface closed.
· Apply: click on Apply after modifying the parameters for the layer. The parameters will be effective with the interface
kept open.
To Next Page