XC3000Series Motion Control System of Laser Cutting - User Manual
V1.0 Raytools AG © Copyright 86 |87
www.raytools.ch
6 Status Bar
The status bar at the bottom of the mainform mainly includes Draw (drawing log), Log (system log), and Alarm (system
alarm). Click on the button to switch to view other logs, as follows:
6.1 Draw
The drawing log reminds and leads the operations when the user is drawing or editing the graphics, as shown below:
6.2 Log
The system log is mainly used to record the operations to the system, as shown below:
To Next Page