What to do if the RCm Floor Machine does not dry well?
If your RCm Floor Machine isn't drying properly and leaves water traces, there are several potential causes: * Ensure the aspirator is on. * Check for and clean any blockages in the aspiration tube connecting the squeegee to the recovery tank. * Empty the recovery tank if it's full. * Inspect the squeegee rubber blades for wear; replace or turn them over if needed.
Why my RCm Floor Machine won't start?
If your RCm Floor Machine fails to start when you turn the key, it could be due to a few reasons. If you have the BC version, check if the battery is low and needs charging or if the main fuse (RED 40A) is blown and needs replacement. If you have the E version, make sure the plug is properly connected.
What to do if no water comes out of RCm Floor Machine?
If no water is coming out of your RCm Floor Machine, try these steps: First, check if the tank is empty and fill it if necessary. Then, ensure the solenoid valve enabling button is pressed. Also, verify that the tap at the bottom of the machine is turned on. Finally, inspect the filter for any blockages and clean it.
Why the brush does not rotate on my RCm Floor Machine?
If the brush on your RCm Floor Machine isn't rotating, check these items: First, replace the GREEN 30A brush motor fuse if it's blown. Also, make sure you have pressed the brush rotation enabling button.
What to do if the aspirator does not work on RCm Floor Machine?
If the aspirator on your RCm Floor Machine isn't working, verify these two things: First, replace the YELLOW 20A aspirator motor fuse if it has blown. Second, ensure that the aspirator enabling button is pressed.
General| Brand | RCm |
|---|---|
| Model | BIT 391CB |
| Category | Floor Machine |
| Language | English |
To Next Page
