RCm BIT 391CB - Emptying and Cleaning the Clean Water Tank; Maintenance and Cleaning

Fig. 14
3
2
1
EN
EN-18
11.1 MAINTENANCE AND
CLEANING
WARNING:
For information and warnings regarding
maintenance or cleaning, follow the in-
formation given in the “General warnings
during maintenance” in chapter 1 in this
manual.
OPERATIONS TO PER-
FORM DAILY
11.1.a - Emptying and cleaning the
clean water tank (Fig. 14)
WARNING:
At the end of the washing operations, it is
compulsory to drain and clean the clean
water tank to prevent deposits or scal-
ing.
After draining the recovery water tank, drain
the clean water tank as follows:
- Position the machine over a drain outlet.
- Turn the drain connector outwards (1).
- Push the hose clip (2) inwards and at the
same tie remove the cap (3) and let all
the water drain out.
- Wash the inside of the tank, leaving the
drain cap open and adding clean water
through the front opening.
- After cleaning, replace the cap (3), push-
ing inwards.