RCm BIT 391CB - English

EN
EN-2
Technical data .....................................................................................................EN-3
1.1 Introduction ................................................................................................EN-4
1.1.a Purpose of the manual .......................................................................EN-4
1.1.b Consulting the manual........................................................................EN-4
1.1.c Key to symbols used in the manual....................................................EN-4
1.1.d Conventional terminology ...................................................................EN-4
1.2 General warnings .......................................................................................EN-4
1.2.a Personnel qualifications .....................................................................EN-4
1.2.b Operator position ................................................................................EN-5
1.2.c Protective clothing ..............................................................................EN-5
1.2.d General warnings before use .............................................................EN-5
1.2.e General warnings while using the machine ........................................EN-5
1.2.f General warnings about the batteries ................................................EN-5
1.2.g General warnings during maintenance...............................................EN-5
1.2.h General warnings in the event of a fire...............................................EN-5
1.2.i Prolonged machine standstill .............................................................EN-6
1.3 Intended machine use ...............................................................................EN-6
1.4 Non-intended machine use .......................................................................EN-6
1.4.a Zone with risk of explosion .................................................................EN-6
1.5 Demolishing the machine .........................................................................EN-6
1.6 Reference standards .................................................................................EN-6
2.1 Unpacking ...................................................................................................EN-7
2.1.a Standard machine equipment ............................................................EN-7
3.1 Assembling the components ....................................................................EN-7
3.1.a Positioning of the handle ....................................................................EN-7
3.1.b Connecting the batteries (for BC version only)...................................EN-8
3.1.c Electrical connection (for E version only) ...........................................EN-8
3.1.d Assembling the brush .........................................................................EN-9
4.1 Charging the battery (for BC version only) ...........................................EN-10
5.1 Getting to know the machine ..................................................................EN-11
6.1 Control panel ............................................................................................EN-12
7.1 Lever for handle angle regulatio ............................................................EN-13
8.1 Filling the tank ..........................................................................................EN-14
9.1 Operation ..................................................................................................EN-15
9.1.a Checks before use ...........................................................................EN-15
9.1.b Preparing the machine and choosing the cycle................................EN-15
9.1.c Using the machine............................................................................EN-16
9.1.d End of use and switching off ............................................................EN-16
10.1 Draining the recovery water....................................................................EN-17
11.1 Maintenance and cleaning ......................................................................EN-18
11.1.a Emptying and cleaning the clean water tank ...................................EN-18
11.1.b Cleaning the recovery water tank ....................................................EN-19
11.1.c Cleaning the squeegee ...................................................................EN-20
11.1.d Cleaning the clean water filter .........................................................EN-21
11.1.e Replacing the brush ........................................................................EN-21
11.1.f Replacing the squeegee rubber blades ..........................................EN-22
11.1.g Replacing the fuses (for BC version only) .......................................EN-22
Troubleshooting ..............................................................................................EN-23
Wiring diagrams ..............................................................................................EN-24
BC version .................................................................................................EN-24
version E ....................................................................................................EN-25
Contents