Reer Mosaic Series User Manual

Mosaic fieldbus modules
8540801 • 01/02/2017 • Rev.15 9
Second input KO
Redundancy check failed on input
OUT_TEST diagnostics OK
Output connected to other inputs
Test output not connected to the right input
Output OK but input connected to
24VDC
Stucked input
Short circuit between photocell
test and photocell input
Photocell response time too low
No response from photocell
The test signal on the photocell emitter is not seen on the receiver
Short circuit between photocells
The test signal is present on two different photcells
MAT disconnected
Wrong mat connection
Output inconsistent with feedback
The test signal on input is present on more than one OUT_TEST
Connection incorrect
The test signal is present on more than one input
Output stuck
The test signal on the input is not present on the OUT_TEST
Second OUT_TEST KO
Redundancy check failed on OUT_TEST
MV2 proximity missing
Proximity not present / Proxy not working
MV2 encoder missing
Encoder not present / Encoder unpowered
MV2 encoder Proximity missing
Device connected incorrectly
MV2 Proximity1, Proximity2
missing
Both proxy must be connected
MV2 encoder1 encoder2 missing
Both encoder must be connected
MV2 error congruence frequencies
redundancy check failed on the measure.
MV2 encoder supply missing.
Encoder not properly fed
MV2 Encoder error
Encoder signals with duty cycle and / or phase displacement not correct
TWO-HAND concurrent failed
Two-hands switch has to change state simultaneously
Not started
Start test failed
Waiting for restart
The input has manual reset and has not been restarted
Table 3

Reer Mosaic Series Specifications

General

Type	Control Unit
Series	Mosaic
Manufacturer	Reer
Input Voltage	24 VDC
Output Voltage	24 VDC
Protection Degree	IP20