Reliance flexpak plus - Voltage; Tachometer Follower; Modification Kit Quick Reference List; Auxiliary Panel

5.2 Dynamic Braking - The standard FlexPak Plus con-
troller allows a drive motor to coast to rest after the STOP
switch is pre ssed. Optionally, a user may install a Dynamic
Braking Kit. (Refer to Figure 5.3 .) Its use allows a rapid,
shockless stopping of the drive motor .
Dynamic Braking is
not a mechanical holding brake. It will
not hold the shaft in place, nor will it prevent the motor
from turning once motion has stopped.
Table 5 .A
Figure 5.3 - Dynamic Braking Kit
MODIFICATION KIT QUICK REFERENCE LIST
ADDITIONAL ADDITIONAL
MANUAL
CONTROLLER OPTIONS USER-
PARAGRAPH
MODEL
MODIFICATION REQUIRED SUPPLIED
KIT
NUMBER
NO.
7a) 7 OPTIONS REQUIRED PARTS?
Automatic
5.4
14C226 no
yes
• Auxiliary Panel no
Reversing
• Reversing Contactor Kit
Auxiliary
5.10
14C219
no
M Contact
yes
Auxiliary Panel
wire©
©
Auxiliary
5.1
14C80
yes no
None
no
Panel
thru 83
Contactor
5.14
14C276 no no None M Contactor
Adapter Kit
wire©
Dancer
5.12
14C230
yes yes
Dancer Potentiometer
wire©
Follower
Dynamic
5.2 14C214
no
yes
Auxiliary Panel
no
Braking
thru 16
Field Supply
CD
5.8
14C237
no
no None
wire@
Instrument
5.7
14C222 yes no/ yes • If preset speed only , may no
Interface /
need AUTO/ MANUAL
Preset Speed
switch .
no/ yes
• If follows process con-
wire ©
troffer, may need AUTO /
MANUAL switch.
Master Isolated
5.13
14C229 yes yes Master Isolated
wire©
Reference
Reference Transmitter
Receiver©
Reversing
5.3 14C218
yes
yes
• FORVVARD/ REVERSE
no
Contactor
selector switch on
Operator Station
(See Figure 3.4.)
• Auxiliary Panel no
Tachometer
5.5
14C221
yes
no
None
wire©
Feedback
Test
Meter
5.11
14C225
no no None no
Adapter
Torque Taper
5.9 14C224
yes
no
None
no
Voltage/
5.6
14C223
yes no/ yes
May need AUTO/ MANUAL
wire ©
Tachometer
selector switch
Follower
<D Modification here means that some work such as jumper placement, resistor clipping, or wiring reconnection. must be performed.
<D Refer to Table 5.C.
<D Supplied as standard with 2, 3 and 5 hp FlexPak Plus controllers.
© Not to exceed AWG No. 14.
© Refer to Paragraph 5.8 for specific sizes.
© Special order only.
20