Rem GrainVac VR12 - Overhead Power Lines

REM - GRAINVAC VR12 2. SAFETY
2.4. OVERHEAD POWER LINES
9000-00-0042 R3 11
• Place equipment on reasonably level ground when raising, lower-
ing, positioning, or operating.
• Chock wheels after placement.
• Lower equipment at completion of operation or when not in use.
• Keep the work area clean and free of debris.
• Keep out from under equipment and undercarriage area.
• Keep away from the unloading auger when moving, adjusting, or setting (due to
pinch points). Keep others away.
Figure 2.1 Work Area Safety Diagram
2.4. Overhead Power Lines
• When operating or moving, keep equipment away from overhead power lines and
devices.
• This equipment is not insulated.
• Electrocution can occur without direct contact.