Rem GrainVac VR12 - 3. Transport; 3.1. Transport Safety

REM - GRAINVAC VR12 3. TRANSPORT
3.1. TRANSPORT SAFETY
9000-00-0042 R3 27
3. Transport
Before continuing, ensure you have completely read and understood this manual’s
Safety chapter, in addition to the safety information in the section(s) below.
3.1. Transport Safety
• Never move the GrainVac with the auger in working position. Ensure the auger is in
transport position before transporting.
• Use a proper towing vehicle to move equipment.
• Never attempt to move the equipment manually. To do so will result in serious injury.
• Before starting, check with the local authorities to make sure you are in compliance
with all local rules and regulations governing transporting agricultural equipment on
public roads and highways. Consult your local law enforcement agency for details.
• If transporting below 40 mph (65 kph), attach an SMV (slow moving vehicle) sign
before transporting. Use the necessary lights and reflectors for transportation where
required by law, and keep them clean. Always use hazard warning flashers on the
tractor/towing vehicle when transporting, unless prohibited by law.
• Securely attach equipment to towing vehicle with correct pin, mechanical retainer,
and safety chains. Use a type of hitch pin that will not allow the equipment to sepa-
rate from the towing vehicle during transport.
• Before transporting the equipment, make sure the area around the equipment is
clear of obstructions and/or untrained personnel. Never allow anyone to stand on or
beneath the equipment when it is being transported. Do not allow riders on the
equipment or the towing vehicle.
• Never transport faster than highway speeds, or what the road surface conditions or
towing vehicle safely allow. Provide ample clearance for obstacles and oncoming
and overtaking traffic. Take special care and precautions when transporting during
times of limited visibility such as rain, fog, snow, dusk, or at night.
• Know where overhead electrical lines are located and stay away from them. Electro-
cution can occur without direct contact.