REM - GRAINVAC VR12 7. STORAGE
7.3. REMOVING FROM STORAGE
9000-00-0042 R3 89
7. Remove any material caught at the auger joint.
8. Inspect the end dump double doors and remove any material in that area. Make
sure they seat well and seal along the edges. Refer to Section 5.4.7. on page 62 for
airlock adjustment instructions.
9. Grease all the fittings on the machine and driveline.
10. Oil the auger drive chain.
11. Touch up all paint chips and nicks to prevent rusting.
12. Ensure the exhaust lid is in place and closed to keep all moisture out of the exhaust
and rotor housing.
13. Store the GrainVac away from areas of human activity.
Note: Over-exposure to the sun will cause deterioration of rubber/plastic hoses. Store all
hoses inside a clean, dry environment, making sure that the rubber/plastic hose has no
bends, and is lying in a straight, flat position.
7.3. Removing from Storage
1. Open the side plate inspection panel and remove debris.
2. Check the tension of the chain and belts. Adjust as required to the correct tension.
Refer to Maintenance chapter on page 49.
3. Perform steps in Pre-Operational Checklist on page 31.
To Next Page
Loading...