REM - GRAINVAC VR12 4. OPERATION
4.1. OPERATING SAFETY
9000-00-0042 R3 31
4. Operation
Before continuing, ensure you have completely read and understood this manual’s
Safety chapter, in addition to the safety information in the section(s) below.
4.1. Operating Safety
• Keep away from rotating and moving parts, including the drive com-
ponents, shafts, and bearings.
• Always operate with guards, covers, and shields in place.
• Shut down and lock out all power before maintaining, adjusting, or
unplugging the equipment.
• Have another trained person nearby who can shut down the equip-
ment in case of accident.
• The work area should be kept clear of bystanders.
• Place equipment on reasonably level ground before operating.
• Chock wheels after placement.
• Keep the work area clean and free of debris.
• Ensure that the GrainVac hitch is securely attached to the tractor drawbar using a
properly sized draw pin with a secure mechanical retainer. Ensure pin is properly
placed. Ensure safety chain is securely attached. Use a type of hitch pin that will not
allow the GrainVac to separate from the tractor.
• Stay away from overhead obstructions and power lines. Electrocution can occur
without direct contact.
4.2. Pre-Operational Checklist
Before initially operating the GrainVac and each time thereafter, the operator must
confirm the following:
• Proper maintenance has been performed.
• All fasteners (except tapered hubs) are torqued to the values in Section 9.2. on
page 96.
• PTO driveline is connected and secure. Check both ends of the PTO to ensure that it
is locked fully onto the tractor and the GrainVac respectively.
• PTO driveline shield rotates freely.
• Hydraulic hoses are in good condition.
• Hydraulic connections are in place and secure.
• All safety guards and service doors are in place and secure.
• Ensure the end dump double doors seal the auger discharge completely.
• GrainVac body, intake hoses, and tubes are free of wear, restrictions, or foreign
material.
To Next Page
Loading...