REM - GRAINVAC VR12 7. STORAGE
7.1. STORAGE SAFETY
9000-00-0042 R3 87
7. Storage
Before continuing, ensure you have completely read and understood this manual’s
Safety chapter, in addition to the safety information in the section(s) below.
7.1. Storage Safety
• Store the unit in an area away from human activity.
• Do not permit children to play on or around the stored equipment.
• Park the equipment on a firm, level, and dry surface.
7.2. Placing into Storage
After the season’s use, inspect all the major systems and components of the machine.
Repair or replace any damaged or worn components to prevent any unnecessary
downtime at the start of the next season.
To prepare for storage, perform the following:
1. Ensure the PTO is not connected to the tractor and park brake is engaged.
2. Wash the machine thoroughly using a water hose or pressure washer to remove all
dirt, mud, debris, or residue. Wash out the optional dust collector if the machine has
been used to move wet grain that may have caused dust to build up inside the
collector.
To avoid damage, do not directly spray the tachometer / hour meter
with a pressure washer.
3. Open the inspection door (from Figure 7.1 to 7.2).
Figure 7.1 Inspection Door Closed
To Next Page
Loading...