REMEHA Selecta - General Specifications

13
Electrical
Main supply V/Hz 230 / 50
Power consumption
max.
W 130
Insulation class IP 20
Fuse rating A 3
Table 01 Technical details
* with Broag Kit No.1 and calorifier
3.3 General Specifications
(to be read with above table)
- One piece cast aluminium heat exchanger
- 22 mm Ø (m) flow and return connections
- 15 mm Ø (m) gas connection
- Maximum operating pressure of 3.0 bar
- Maximum operating temperature of 95°C
- Low NOx, < 25 ppm (O
2
= 0%)
- Pre-mix, fully modulating (25 -100%) gas burner with gas/air ratio control for maxi-
mum efficiency
- Intelligent advanced boiler control ‘abc’ c/w a comprehensive operating, service
and fault diagnostic facility
- Available for room sealed operation
- Supplied fully factory assembled
- Powder coated enamel steel casing and plastic front panel with cover
- Suitable for use with a Natural gas (standard) or propane (with optional kit)
- Efficiency of 98% at 80/60 °C (Hi)
- Max. efficiency of 109.2% (Hi) in fully condensing mode
- Manufactured to ISO 9001
- CE approved
- British Gas Approval Service listed
- Kiwa (Water regulations) approved product
- Flow temperature sensor DHW (for combi boiler only)
- 3-Way valve (for combi boiler only)
- Plate heat exchanger (for combi boiler only)