REMEHA Selecta - 1 General Requirements

Remeha Selecta
6
1 GENERAL REQUIREMENTS
Under the Gas Safety (Installation & Use) Regulations 1998, the Remeha Selecta, in
common with all gas appliances, must be installed by a competent person in accordance
with that regulation. Statutory regulations in any country, cannot be overridden by any
of the notes or instructions from the manufacturer. Compliance with National Standards
does not provide any degree of immunity from legal obligations. In the UK, the instal-
lation must be in accordance with the national and local norms and requirements. In
normal operation, the boiler will produce a visible white “plume” of condensation. In
addition, the condensate produced by this type of condensing boiler is drained from the
appropriate point indicated within the instructions. For any issues or circumstances not
addressed within these instructions, please call our Customer Care Department.
The boiler meets the requirements of the EC regulations at the folowing directives:
- 90/396EEC Gas appliances directive
- 92/42/EEC Efficiency directive
- 73/23/EEC Electrical low voltage directive
- 89/336/EEC EMC directive
- 97/23/EEC Pressure equipment directive (art. 3, sub. 3)
The Remeha Selecta (Combi and System) is a Kiwa (Water regulations) approved
product. Certificate number: A030497
Fig. 01 Kiwa logo
pdf
Remeha Selecta (Combi and System) - PIN: 0063BL3537
Gas Council numbers: Remeha Selecta combi: 47-673-01
Remeha Selecta system: 41-288-01
Classification type for evacuation of the combustion products; according EN 483: see
Par. 4.4 and Par. 4.5.
Health and safety information
- The weight of the Selecta system and combi boilers exceed the maximum lift weight
for one person.
- All sealants and gaskets are free from harmfull products. On first firing the boiler, a
smell of these products may be present and should cease after a short period.