14 MAN-GD-2300-002
Row Spacing
Opener with No-Till Coulter & 2 x 13 Press Wheel
Row spacing can be changed easily from your current width to any row width you desire, within the
limits of the over-all drill width. Determine the row width desired. Each opener unit may be easily moved right
or left on the pull bar by simply loosening two U-bolts. If you do not wish to use all attached opener units, cap
off the un-needed meters. Optional meter covers are available.
Recommended Torque Specifications
SAE Grade No. 5 8
Bolt Head
Identification
Bolt Size Lb. - Ft N - m Lb. - Ft N - m
1/4” 9 - 11 12 – 15 12 - 15 16 - 20
5/16” 17 - 20.5 23 – 28 24 - 29 33 - 39
3/8” 35 – 42 48 - 57 45 - 54 61 - 73
7/16” 54 – 64 73 - 87 70 - 84 95 - 114
1/2” 80 - 96 109 - 130 110 - 132 149 - 179
5/8” 150 – 180 203 - 244 220 - 264 298 - 358
3/4” 270 – 324 366 – 439 380 - 456 515 - 618
7/8” 400 – 480 542 – 651 600 - 720 814 - 976
1” 580 - 696 787 – 944 900 - 1080 1220 - 1464
1-1/8” 800 – 880 1085 – 1193 1280 - 1440 1736 - 1953
1-1/4” 1120 – 1240 1519 – 1681 1820 - 2000 2468 - 2712
1-3/8” 1460 – 1680 1980 – 2278 2380 - 2720 3227 - 3688
1-1/2” 1940 - 2200 2631 – 2983 3160 - 3560 4285 - 4827
To Next Page
Loading...