Renault F9Q - Page 849

19A-82
COOLING
Engine cooling fan assembly: Removal - Refitting
F4R
19A
REFITTING
I - REFITTING OPERATION FOR THE PART
a Refit the fan assembly.
a Clip the fan assembly wiring onto the fan assembly.
a Connect:
-the fan assembly resistor connector,
-the motor-driven fan assembly connector.
II - FINAL OPERATION
a Refit the intercooler air outlet pipe (see 12B, Turbo-
charging, Intercooler air outlet pipe: Removal -
Refitting, page 12B-56) .
a Fit the front end panel.
a Refit:
-the lower bolts from the front end panel,
-the front end panel clips,
-the front end panel upper bolts,
-the bolts of the wiring channel of the engine cooling
fan assembly,
-the bonnet catch (see Bonnet latch: Removal -
Refitting) (52A, Non-side opening element mecha-
nisms),
-the front impact cross member (see Front impact
cross member: Removal - Refitting) (41A, Front
lower structure),
-the audible warning (see Horn: Removal - Refit-
ting) (82B, Horn),
-the front bumper supports (see Front bumper
support: Removal - Refitting) (42A, Front upper
structure),
-the headlights (see Front headlight: Removal -
Refitting) (80B, Headlights),
-the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-7) ,
-the side air deflectors,
-the upper air deflector,
-the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
-the front section of the front wheel arch liners (see
Front wheel arch liner: Removal - Refitting)
(55A, Exterior protection),
-the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the engine undertray,
- the engine cover.
a Connect the battery (see Battery : Removal - Refit-
ting) (80A, Battery).
a Adjust the headlights (see Front headlight: Adjus-
ting) (80B, Headlights).