Renault F9Q - Page 870

19A-103
COOLING
Coolant temperature sensor: Removal - Refitting
K9K
19A
REMOVAL
I - OPERATION FOR REMOVAL OF PART
CONCERNED
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
-the engine cover,
-the battery (see Battery : Removal - Refitting)
(80A, Battery),
-the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
-the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
-the front section of the front wheel arch liners (see
Front wheel arch liner: Removal - Refitting)
(55A, Exterior protection),
-the engine undertray bolts,
-the engine undertray,
-the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection).
a Drain the cooling system (see 19A, Cooling, Coo-
ling circuit: Draining - Refilling, page 19A-17) .
a Unclip the expansion bottle bottom cooling hose (1)
from the coolant outlet unit.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the coolant temperature sensor connec-
tor (2) .
a Remove:
- the clip (3) from the coolant temperature sensor,
- the coolant temperature sensor,
- the coolant temperature sensor seal.
IMPORTANT
Wear leaktight gloves (Nitrile type) for this opera-
tion.
135484
114213