19A-104
COOLING
Coolant temperature sensor: Removal - Refitting
K9K
19A
REFITTING
I - REFITTING PREPARATION OPERATION
a parts always to be replaced: coolant temperatu-
re sensor seal (10,06,01,18).
a Use SURFACE CLEANER (see Vehicle: Parts
and ingredients for the repairwork) (04B, Consu-
mables - Products) to clean and degrease:
-the mating face of the coolant temperature sensor
if it is to be reused,
-the coolant outlet unit.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
-a new coolant temperature sensor seal on the coo-
lant temperature sensor,
-the coolant temperature sensor,
-the coolant temperature sensor clip.
a Connect the coolant temperature sensor connector.
III - FINAL OPERATION
a Clip the expansion bottle bottom cooling hose onto
the coolant outlet unit.
a Refit:
-the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
-the engine undertray,
-the front section of the front wheel arch liners (see
Front wheel arch liner: Removal - Refitting)
(55A, Exterior protection),
-the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
-the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
-the battery (see Battery : Removal - Refitting)
(80A, Battery),
-the engine cover.
a Fill and bleed the cooling system (see 19A, Coo-
ling, Cooling circuit: Draining - Refilling, page
19A-17) .
To Next Page
