EasyManua.ls Logo

Renault MASTER 2024 - Page 229

Renault MASTER 2024
404 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ADDITIONAL DRIVING AID FUNCTIONS
3
Driving - 227
warning light continues to flash
or, depending on the vehicle, the
warninglightandtheindicator
9
on the side of the crossed line change
to red on the instrument panel. This is
accompanied by a vibration on the
steering wheel.
When the "Operation on broken line"
setting is not selected, the function
sounds the alarmifthevehiclecross
es a broken line without activating the
directionlights,andthereisnoroad
side close enough to the line.
Inthiscase,thefunctionwarnsthedri
ver:
by a vibration in the steering wheel;
and
the warning light flashes in
white or, depending on the vehicle, the
warning light and the indicator
9
on the side of the crossed line change
to red on the instrument panel.
Note: on bends, the function allows for
slightly cutting the bend.
Special cases
If the system is operating and does
not detect any activity on the steering
wheel,the"Keepcontrol"messageap
pearsontheinstrumentpanelaccom
panied by a beep and, depending on
the vehicle, the warninglightap
pearsinyellowuntilthedriverhasre
gained control of the vehicle.
or
If the system has been in operation
fortoolong,the"Keepcontrol"mes
sage appears on the instrument panel
accompaniedbyabeepand,depend
ing on the vehicle, the warning
lightappearsinyellowandtheindica
tor
4
on the side of the line concerned
flashes until the driver has regained
control of the vehicle.
Youcaninterruptthetrajec
tory correction at any time
by moving the steering
wheel.
Settings
For safety reasons, carry
out any adjustments
whilethevehicleissta
tionary.
Adjustingsettingsfromthemulti
media screen
3
To access the function settings from
the multimedia screen
3
, refer to the
multimedia instructions:
"Operation on broken line": use this
setting to select the response of the
function if the vehicle crosses a broken
linewithoutactivatingoneofthedirec
tion indicators:
selected setting: the function may
trigger an action on the vehicle's
steeringsystemtocorrectthevehi
cle trajectory;
setting not selected: the function
can warn the driver by means of a
vibrationatthesteeringwheelwith
out correcting the vehicle trajectory.

Table of Contents

Related product manuals